 ITW Dynatec’s APEX High Speed Slot Die Applicator is an air-operated hot melt adhesive applicator
assembly with an optional filter manifold. The applicator is used with intermittent pressure and
constant pressure hot melt adhesive supply units (ASUs). APEX models are offered in six different
module configurations.
Each APEX High Speed Slot Die applicator features various combinations of adhesive valve slot
die modules mounted to a single service block. Each module is opened and closed by air pressure.
Springs are used to keep needles closed when no air pressure is supplied to the head. The rate of
adhesive flow from the applicator is determined by the adhesive pressure applied by the ASU’s
pump, shim thickness and the amount of shim opening.
The
applicator is heated by replaceable cartridge heating elements which
are controlled by an integrated RTD sensor and electronic control. A
single heat zone for the service block and die allows for only one
temperature control point on models less than 390mm. Models longer than
390mm have two heat zones and control points. The APEX module(s) is
mounted onto either a steel or aluminium service block. A piston inside
the module is pneumatically triggered by a solenoid, which allows
adhesive to flow through a valve within the module.
The APEX offers a variety of heated adhesive supply hose connections
into the service or filter manifolds. Adhesive flows from the hose into
and through the channels within the manifold to the module. Air
pressure opens the adhesive valve, allowing adhesive to flow through
the module’s die assembly when the valve is open.
In
order to minimize response time, operating air and electrical connects
from the solenoid valves are made to each individual module
These
slot die applicators can be configured for either ITW Dynatec’s
DynaControl controller, Microprocessor Temperature Control/ Compu-
Vision (MCV), DynaPlus/ Pro or it can be configured for a competitive
upgrade.
Features:
- Precise high speed intermittent adhesive patterns
- Self-cleaning die lips permit the use of a variety of adhesive viscosities
- Exceptional value for a high speed slot die applicator
- Slot die design does not require micro adjustments to achieve the required adhesive lay down weights
- APEX™ SB module with recirculation provides a clean adhesive cutoff regardless of the adhesive patter
|
